Your AmpForge dashboard

Set it up, design its screens and keep it up to date - from your browser.

Latest firmware v1.8.0
Phone or computerDashboard setupUnits, battery, speed, display. Over Bluetooth or the USB cable. Phone or computerLayout designerMove and resize the speed, gauges, battery and tiles. Charging screen too. USB cableBackup & product keySave or restore everything, or activate the dashboard.

1Before you start

  1. Park the scooter and switch it off. Never update while riding.
  2. Use Chrome or Edge on a computer (Windows, Mac, Linux or Chromebook). Updates need the cable - Bluetooth is only for settings and layouts.
  3. Connect the dashboard to the computer with a USB-C data cable.
  4. Recommended: save a backup of your settings first with the dashboard tools (needs v1.6.0 or newer on the dashboard).

2Install the update

This browser cannot update the dashboard. Open this page in Chrome or Edge on a computer. This page must be opened over https.
  1. Pick the port named USB JTAG/serial debug unit (or ESP32-S3) and click Connect.
  2. Click Install. When it asks "Erase device?", leave the box unticked and click Next, then Install.
  3. Wait about a minute. Do not unplug the dashboard until it says the installation is complete.

What is kept

Your settings, riding modes, dashboard layout, odometer and trip stay as they are. Only the firmware is replaced.

Only if you tick Erase device is everything reset to factory defaults, including the odometer. Do that only if support asks you to.

When it has finished, the dashboard restarts by itself. The version is shown at the bottom of the SETUP tab.

Troubleshooting

No port appears in the list

Try another USB cable: many cables only charge. Try another USB port on the computer.

"Failed to connect" or the update stops
  1. Hold the BOOT button on the dashboard board.
  2. Press and release RESET, then release BOOT.
  3. Click Install again. The screen stays dark during the update; that is normal.
  4. When it is done, press RESET once.
The update was interrupted

The dashboard cannot be damaged by an interrupted update. Reconnect it and click Install again (use the BOOT / RESET steps above if needed).